Is there a moderator monitoring this group? Â ... From: Walter <ipnfla124@...> Subject: Re: [BCD396XT] Need Keys Urgently - just for 10 - 15 minutes...
EXCUSE ME! You are the guilty one, you didn't read the entire thread! I said I HAVE THE KEYS AND HAVE GONE THROUGH THE PROCESS (It takes a little time to...
Actually, it IS illegal.  Soliciting to do an illegal activity is just as illegal as doing the activity.  And you're right...I don't know you, nor do I...
Is there a way to set Close Call so that when it captures a new freq. it will just display it without telling me "press any key" or "press fuction key" I want...
To Don and Jeffry, Actually to ask is NOT illegal, and further more, who put you two, (The group Nazi's) in charge to judge me anyway, why don't you cast the...
Sounds very fishy to me. No one should give him anything. ... From: Joe Polcari <Joe@...> Subject: RE: [BCD396XT] Need Keys Urgently - just for 10 - 15...
Sure hope your getting paid to program the radios for the "watch captain"... ... From: "Walter" <ipnfla124@...> To: <BCD396XT@yahoogroups.com> Date:...
I posted this in another group, so I will here also: For some reason, FreeScan AND Proscan can WILL NOT work on my PC for some reason!?!?!? I used to use it...
1. You need to contact Butel about this to get replacement keys. 2. Butel has a demo mode, so it will work for a period of time if you install it on a...
Hi Walter, How about using FreeScan instead? It's just as good or better than the Butel ARC and best of all it is FREE. http://www.scannow.org/ Cheers, dwC ......
Hello Gentlemen, I am looking for the 2 serials for ARC396Pro V 3.2.004 Pro - and ARCXTPro V 1.5 Build 4, (Both take 2 "serials" actually "keys" , Key 1 and...
You don't need the new rebanded frequencies until the old ones stop working. Once they reband, you will have to add the new control channel frequencies and...
In my area, Montgomery County, Ohio, the TRS page on Radio Ref gives a few frequencies off the grid that are rebanding control channels. Still learning trunk...
I think he was meaning that this group is supposed to be focused to 396XT issues not generic scanners topics at length that are better covered in other groups...
How is antenna's and coax off topic? Last I heard both are required (depending on setup regarding coax) for scanners to hear what you want to hear. So it...
... Andrew Heliax is a common brand name for hardline. And it's not really hard because the shield is a corrugated copper tube so it has some flexibility. The...
What is the name or designation for "hard line ?" Is LMR-600 the same as "hard line ?" I was asking because I saw some at construction project - specifically...
No antenna (except for a dish and not quite that even) is perfectly directional. There are lobes all around every type of antenna including a Yagi-Uda, log...
Imagine working 2 meters from the space shuttle... ... From: "Michael Hopkins" <mhopkins735@...> To: <BCD396XT@yahoogroups.com> Date: Tue, 1 Feb 2011...
If that was the case then I would not be able to recieve signals from a yagi antenna using a omni-directional antenna... In the same light, a Southwest Jet...
Yeah, but transmitting and receiving patterns are typically reciprocal --- a directional transmitting antenna will also be a directional receiving antenna…....
Sometimes what you think might be a great place for a scanner and antenna isn’t such a good thing. I had a small airplane for a while (Piper Warrior II) and...
"because the antenna’s major radiating (and receiving) pattern will be slightly below the horizon and your air duct would block some of that." He is not...
Why not ?? should work fine for most local stuff, but any signals coming in from a higher angle could be significantly reduced (air traffic, for example)...
Scanner Master has a few log periodics one of them is 4 grand! Put that on a tall tower and some LMR 800 and a rotor. Not braging but I have a CLP-5130 log now...
