On the main board of current generation Uniden scanners is a small solder pad labeled "DISC". You can tack-solder a small wire here and run it out to a jack...
Yes, it is present on my 396T, 330 and 396XT, I just haven't opened my 346 yet to check, but it is a pretty safe assumption that Uniden remained consistent. ...
Hi All, Just joined...saw the link on the Uniden Instruction Manual CD. Wow, things have sure changed since my last scanner (circa 1980). Lots of reading...
Well I am starting to get the hang of my new(to me) bc346xt but when I first turn it on the phone number of the original owner comes up. To this point I cannot...
... Well I Use Freescan To Program My 346XT,,,And If You Open Freescan,,Click / Scanner Tap At The Top,,Then /Setup Scanner Options,,And Under The /General...
The discriminator tap is present on the 346. When you open up the radio, you will find two PC boards. These are connected by a plug that separates easily when...
Thanks that did just what I wanted to. There is so much to try to learn sometimes the most basic things are the ones that baffle me the most. Thanks for the...
Can someone explain to me why one would want to do a discriminator tap on a .xt radio? The new versions of Unitrunker do not require one. Neither does Trunk88....
There are several other applications for discriminator audio such as classic Trunker, ATCS Monitor, PL/DPL decoders and other types of data intercepts. While...
down either freescan or Scancat light. On freescan go to scanner, then scanner options. under the general tap you will see 'startup message' on the right. So...
Is there more to the connection than just a pair of wires? I looked at the discriminator tap mod listed on the BCD396T group, and it appears to be just that,...
The resistor or capacitor (I use tantalum capacitors) protects against shorts and stray voltages. While I have never had a problem on the radios I modded...
While I would most likely purchase or trade a used radio with a discriminator tap from Rich, other may not fair as well with a soldering iron. Keep that in...
Rich, I assume the following setup is typical: DISC --------/\/\/\/\--------X-----------||---------- GND Output connection to device at "X" and GND Suggestions...
I use small tantalum caps inline between the DISC solder pad and the jack. The ground is connected directly, so I guess it would look more like: DISC...
The connection at the other end of the scanner is fairly rare. I've only seen it used on one digital camera from a few years ago and now the PRO-107 also uses...
Ah, I just browsed the owners manual and found many interesting features, including the variable delay, one button start up, and most of all an Auto System...
You understand it correctly. That's what it does. The lockout status will only affect other Systems (or Sites) that have coordinates programmed in and GPS...
Does anyone know if there is a way to change the default setting of the channel selector knob? Out of the box, it's set as channel selector and has to be...
If you lock the keypad, the default becomes Volume. Â UPMan ________________________________ From: avg723 <avg723@...> To: BC346XT@yahoogroups.com Sent:...
I could be going nuts, but I thought that someone had made a comment about being at the CES show in LV Next week. AS I am going to be there I thought it might...
While Uniden will not be on the CES convention floor, we have a private ballroom off-site at Caesar's Palace for the week. I head out tomorrow morning and...
Hi all. I received my long awaited 346XT as a Christmas gift this year. (Think my wife already regrets the purchase!!). I have been working with the included...
