Greetings, ladies and gentlemen, Before you post to the list, there are things you need to know. We currently are operating on an unmoderated basis. When we...
5united@yahoogroups.com
Mar 1, 2009 2:04 pm
34597
http://austin.craigslist.org/mcy/1057579621.html I bought it not knowing anything about airheads, and it was fun. Sadly, I just don't have the time to give it...
Having exhausted every means of procrastination at my disposal, I can no longer avoid rebuilding my headlight/horn switch. Does anyone have a source for the...
Thanks for the reply,Bill. I thought of that, but I am approx 65 miles from the nearest clock repair shop. I was hoping for an internet source. Hank '72 R60...
A new study done in Japan (of course). http://www.instantnews.net/riding-motorcycles-aids-smart-ageing.aspx -- David Allaband sundiverpress.com ... The Stone...
CaptureHank, Has anyone suggested Small Parts http://www.smallparts.com/?010 ? They have all sorts of good stuff in small quantities. Jim Re: Dip/Horn Switch...
Just received back from my painter my large tank! It's reallly purty and shiney! Have ordered a pair of knee pads from hucky's and am needing a recommendation...
I haven't fully replaced either knee pad but I have had to tack one down across the top and rear on one side. I used 3M Weatherstrip Adhesive to do the job...
... 3M weatherstrip adhesive is what it most recommended. You should be able to find it in black, which is what I would use (as opposed to the yellow...
... I may have screws in good shape on one of the broken switches I have. How many do you need? I'm out in Washington State right now, but when I get back to...
I recommend using a "super glue". I used Loctite 495 which is an instant adhesive. Lay down a bead around the perimeter (inset slightly) of the pad and then a...
I used 3M double sided tape to secure kneepads on my 18L tank, because I wanted to be sure that I could remove them in 1 pc when needed. The bike is garaged...
I think only solids "dissolve" in liquids. Alcohol and water are miscible in that they can form a homogenous solution in any proportion. I have a lot of bikes...
The problem with the liquid adhesives is that they tend to ooze a bit at the edges. I used a liquid adhesive on my big tank and it looks fine, but if I did...
... in that they can form a homogenous solution in any proportion. ************ I suppose it depends on your terminology. Gases, solids and liquids are all ...
Hi Guys, I did a search for this in the archives, but couldn't find what I was looking for. I also am getting an over-full rear bevel drive and an empty drive...
I use 3M brand 5200 adhesive silicon...originally designed for marine applications below the water line. Anyone familiar with boating can testify how it won't...
Hi All, By request, I've added my pics to the /5 photos area http://groups.yahoo.com/group/5united/photos/album/1519941135/pic/list Cheers, H ... From:...
I am going to be in St. Louis March 30 to April 9 working the NCAA basketball tourney. I would like to get together with folks for tire kicking and barley...
HI friends i finished Disassemble the oil pump and the connecting rods the clearance between the inner rotor tip to outer rotor is 0.35 mm (the book say...
The drive shaft housing should be vented into the transmission at the top of the seal behind the transmission output flange. If that is plugged or if some one...
Thomas, Thanks that is a great first step to try before tearing the thing apart and nobody had suggested it. I haven't noticed any ballooning of the boot,...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
