It's called spam. ... From: "Mial P. Wall" <bandlofga@...> To: <4A032@yahoogroups.com> Sent: Sunday, December 10, 2006 7:49 AM Subject: [4A032] trash...
Hi Guys! To keep the newsgroup user friendly, I have chosen not to restrict access or require members to submit for signing up to the newsgroup. This keeps...
set your settings to "moderate new members" all will have the same instant access and no more spam gets through. George Bruce Hotz <shotz@...> wrote: Hi...
Hello, I've been watching these little 4A032 engines, wanting to put one on my ultralight to putt around in. Hope you all don't mind me asking to many...
Welcome to the group Roger, It pretty much depends upon what sort of Ultralight you are planning on. The 4A032 has proven too small to fly the current breed of...
I have prop hubs machined and available for the 042/084. 032 units available by order. With the 042/084 hubs I include up to two Rotax bolt patterns and a...
The conversion of these engines is really interesting. I am looking for a larger engine in the 60-80hp range that might be adaptable to a Titan Tornado or...
Most of us have bought these engines through Government Liquidation Auctions. www.govliquidation.com Go to this site and look for locations near you....
Hey Bruce, I set new members to moderadted status. no approval is need for anyone to join, but all new members from now on will be moderated for a bit. If it's...
Jerry, I'm not sure why, but this group gets hit by spammers much more frequently than my other groups. Most of them are automaticly deleted by Yahoo, but I...
Hi Folks, I'm sending this to a number of lists where it may be pertainent. Sorry if you are on several of the lists and get multiple posts. If you're not ...
... pertainent. Sorry ... you're not ... the ... units ... and a ... 042/084 ... hubs by ron ... will ... length, ... just ... multiple ... found on ... ...
I would like to buy a prop hub for a 4ao32 engine.Ihave a paypal acount i can pay through to or i can send a check but i will not send any money through...
The FAA proposal is out. We're going to be hit with an additional 50 cents per gallon fuel tax, plus fees for aircraft registration, airman certificates, etc....
First, they came for people with Avgas, but I didn't use Avgas, so I did nothing. Then, they came for people flying certified aircraft, but I didn't fly a...
Hey Brother, I took a Mitsubishi starter I got at a junk yard for 10 dollars and of course teeth didn't reach to the flywheel but, the bolt holes lined up so,...
I used a 1991 Mazda starter. The teeth match up fine but as John says the pinion doesn't quite reach. I took the end bell off of the starter and turned the...
Yeah the teeth were about 3/4 of an inch from reaching the flywheel. that is why the starter had to be machined, which sounds difficult but, if you plan ahead...
To vsualize "short" think of a normal starter as it fits into the bell housing. Now imagine a spacer under the starter's mounting ears that causes the starter...
Please forgive me if this question has been asked before. If this is an engine that has its origins in the military, wouldn't one assume the original...
Usually such things are retained at the National Archives. I obtained the manuals for my 084 powered 300amp welder from them. I got routed to them and made a...
Thanks. Good place to start. I did try looking for such things in Library of Congress. Oddly enough, I forgot about the National Archives. If I'm able to...
I really couldn't remember if it was the liberary of Congress or the National Archives. I decided that it must have been the NA but now I'm really starting to...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
